Parr-instrument DP8340R Series Manuale Utente Scaricare il pdf (Pagina 32)

– 28 –

Figure 7-6. Wiring of cable for direct connection between DP8340

and IBM PC serial part

7-6. Peripheral Unit Drive Circuit

The Control Board of this unit is equipped with a circuit for driving a peripheral

unit (Paper Cutter, Take-Up Device, Cash Drawer, etc.)

The Control Board Connector (CN3) is used to connect the Peripheral Unit to the

Drive Circuit. When using this circuit connect the peripheral unit cable to the CN3

Connector (cable is not included). Use a cable with the following specifications:

Note: Do not run cable near devices generating large amounts of electrical

noise.

Figure 7-7. Cable Specifications

7-6-1. Cable Connection

Remove the printer Bottom Cover and connect the cable to the CN3 Connector.

Pass the cable around the control board as shown and through grommetted hole

in bottom cover. (Grommet may have to be cut)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Nessun commento

Parr-instrument DP8340R Series Manuale Utente Pagina 32